Dbv 10 manual






















www.doorway.ru | MODuLAr FLOOr DIFFuSerS - Manual 5 Modular Floor diFFusers PRODUCT OVERVIEW Basket/damper options The seven standard 8 in. distributor baskets (B, BS, DBV, DB, DBS, DBA, DBAS) and four standard 10 in. distributor baskets (B, DB, DBA, DBV) allow for even distribution of supply air through the round floor diffuser. Input LEDs dBFS (switch set to +4 dBu) (switch set to dBV) 0 dBu dBV 3 -3 17 dBu dBV 10 10 dBu dBV 15 5 dBu dBV 20 0 dBu dBV SIG dBu dBV CLIP LEDs When these LEDs light, it indicates that the PA2’s inputs are being overdriven and input clipping is occurring. These. This Manual contains many copyrighted, patented or properly registered equipment items manufactured by JCM, that are prohibited and illegal to duplicate, replicate, copy in whole, or in part, without the express authorization by JCM with Figure DBV Sensor and Roller Cleaning Locations .. Figure DBV ID/MDB Photo.


Sensitivity (LINE): 10 dBV (Manual volume center, full scale dB)/1 kΩ or more Supply Voltage: V DC (Bias resistance: kΩ) USB Terminal. Type-A (USB ) x 1 Media Slot. microSD card slot x 1 (future expansion, recording unavailable) Other Operating Environment. CONCEPT1(T) Instruction manual 19 micro balanced input rear panel gain trim / dBV mic - line micro tone control; rear panel LO - HI Hz / +3 dB, 10 kHz / -6 dB to Hz / -9 dB, 10 kHz / +4dB pre-out impedance / sensitivity 1 kohm / 0 dBV line-out impedance / sensitivity 1 kohm / +3 dBV general. AUX 3 - 4: 20 dBV, 10 kOhm, unbalanced, RCA pin jack AUX 5: 20 dBV, 10 kOhm, unbalanced, combined type of XLR equivalent and phone jack PWR AMP IN: 0 dBV, Ohm, unbalanced, RCA pin jack (An equalizer or other signal processor connectable between LlNE OUT and PWR AMP IN terminals) Outputs: REC: 0 dBV, Ω, unbalanced, RCA pin jack.


Product Manuals All Product Manuals are available in Adobe PDF format. 10 MB: PDF File | Revision: A | 04/12/ DBVR Operation and Maintenance Manual. 10 mV RMS Maximum Input Level: +10 dBV, 3 V RMS Preamp Low Gain Input: Impedance: High Z, 44K ohms Nominal Input Level: 14 dBV, mV RMS Minimum Input Level: 34 dBV, 20 mV RMS Maximum Input Level: +16 dBV, 6 v RMS Crossover High/Chorus Out- put: (High Pass Output) Load Impedance: 1 K ohms or greater Nominal Output Level: O dBV, 10 V RMS. DBV Bill Validator Operation and Maintenance Manual (Rev B) JCM Part No. $10, $20, $50, $ (and currencies of other countries) Bill insertion 4-way.

0コメント

  • 1000 / 1000